Tollesboro KY Demolition Derby

07/19/2021

Get those cars here, going to start power wheelers at 7:30

07/19/2021

07/19/2021

Inspection starts at 5, power wheels will start at 7:30 so be sure to get thru inspection and get signed up. Thanks

07/18/2021

Starting power wheels at 7:30 tomorrow night, please get signed in before then. Can’t wait to see everyone

07/12/2021

O

07/12/2021

Small Truck and Van Rules

1. You are allowed a 4point cage NO BARS OR TUBING LARGER THAN 6in. Can't go past the firewall and must no touch frame or floor in any way. No kickers or down legs in front or back. You can run a bar behind the driver's seat its your choice, it can have 12in plate at each end with no more than 4 bolts on each end. Rollover bars are permitted no bigger than 2in x 2in square tubing window bar in front is permitted

2. V8 ENGINES IN THIS CLASS are permitted as long as it came factory that way

3. You are permitted to wire or chain doors,hood and trunk in 4 spots with 4 strands of #9 wire per spot or 3/8 dia. chain. You can weld doors only 6in. on 6in. off pattern. THE DRIVERS DOOR ONLY CAN BE REINFORED.

4. Factory gas tank can stay under truck as long as it is in front of the rear axle or can be moved to the back seat area with boat type tank or in the bed against cab

5. ALL GLASS MUST BE REMOVED.

6. No use of extra bolts or washers. tank PROTECTORs are permitted

7. THERE MUST BE A 12in. x 12in. HOLE IN THE HOOD.

8. HOOD AND TRUNK MUST BE OPEN FOR INSPECTION.

9. Any tire is permitted, doubling and tubing of the tire are allowed as well as valve stem protectors. Wheels have to be stock.

10. You are permitted to move the battery inside the car, it must be mounted securely. It can not strengthen the car in any way. A rubber mat must cover the battery and gas tank.

11. You may weld a square tube type bumper on the front and rear of truck

12. no larger than 6in. tube in front and no larger than 4in. tube on back. You are allowed a point on the front bumper no longer than 30in and no wider than 10in from point to the back of the bumper. If its any bigger you will cut! NO HOMEMADE BUMBER SHOCKS!! 1/4in. wall must be open on both ends.

13. You're allowed to weld the rearends POSI.

14. Any American made truck of any year is permitted.

15. Patch plates 4 on fresh, 6 on prerun, 4x4x1/4 plates, must have gap between the plates

16. YOURE ALOUD TO WELD FRONT SUSPENSION ONLY

17. If it is a 4 wheel drive ONE DRIVE SHAFT MUST BE REMOVED! It can be front or back BUT ONE MUST BE REMOVED TO MAKE IT A 2 WHEEL DRIVE!!

18. JUDGES WORD IS FINAL!!!!!